Sizing: petal is approximately 1 inch wide.
These floral cutters are designed for creators to use them however they see fit. I like to roll out to a 4 on my pasta machine and then use a ball tool to thin out the petals even more. I also use a petal veiner to add texture. I use six petals per earring for a draped open tulip effect. You can also use the same methods as a ranunculus to create a more closed tulip and thread an eyepin through to use the tulip as a large "bead."
If you need a method to prevent sticking, I prefer to use cornstarch. You can also cover your clay with cling wrap, but this will cause a rounded edge. Press down, wiggle a little, and gently rock back and forth to release. I would also recommend using firmer clay (place in the freezer or refrigerator for a bit if it's soft or sticky).
Jackson & June Polymer Clay Cutters are 3D Printed with PLA. This cutter is NEWLY designed with .3mm edge (the photo is of our original .4mm edge). All of our cutters are made to order. Due to the intricacy of these cutters, extended print time is required. Please check the home page for current cutter processing time.
