Sizing:
Small - .5 in
Medium - .75 in
Large - 1 in
Final flower in photo is approximately 2 in. You can make it however small or large you want by adjusting the petals closer or further from the center.
I like to roll out to a 4 on my pasta machine and then use a ball tool to thin out the petals even more. I like to use a petal veiner on these, too. The gardenia looks best with extremely thin petals.
If you need a method to prevent sticking, I prefer to use cornstarch. You can also cover your clay with cling wrap, but this will cause a rounded edge. Press down, wiggle a little, and gently rock back and forth to release. I would also recommend using firmer clay (place in the freezer or refrigerator for a bit if it's soft or sticky).
Jackson & June Polymer Clay Cutters are 3D Printed with PLA. This cutter is NEWLY designed with .3mm edge (the photo is of our original .4mm edge). All of our cutters are made to order. Due to the intricacy of these cutters, extended print time is required. Please check the home page for current cutter processing time.
