Approximately 1 inch wide (25.4mm)
NOTES ON USAGE FOR 3D FLORAL CUTTERS:
- For impression cutters, I roll my clay out on a 0-2 (thicker settings). The impressions begin 1.5mm into the clay.
- You MUST roll your clay onto the tile and also use a method to prevent sticking. I prefer to use cornstarch. You can also cover your clay with cling wrap, but this will cause a rounded edge. Press down, wiggle a little, and gently rock back and forth to release. I would also recommend using firmer clay (place in the freezer or refrigerator for a bit if it's soft or sticky).
Jackson & June Polymer Clay Cutters are 3D Printed with PLA. These cutters have a 3.5mm cutting edge. All of our cutters are made to order. Please check the home page for current cutter processing time.
