Sizing:
Small - approximately .30in (7.7mm)
Medium - approximately .46in (11.73mm)
Large - approximately .47in (11.86mm)
Extra Large - approximately .56in (14.23mm)
NOTES ON USAGE FOR 3D FLORAL CUTTERS:
- Roll your clay a little thicker than the other 3D flowers (I do a three on my atlas) because succulent petals are thick
- You MUST roll your clay onto the tile and also use a method to prevent sticking. I prefer to use cornstarch. You can also cover your clay with cling wrap, but this will cause a rounded edge. Press down, wiggle a little, and gently rock back and forth to release. I would also recommend using firmer clay (place in the freezer or refrigerator for a bit if it's soft or sticky).
- Build your flower on a tile or on a flower nail (fondant tool).
Jackson & June Polymer Clay Cutters are 3D Printed with PLA. These cutters have a 3.5mm cutting edge. All of our cutters are made to order. Please check the home page for current cutter processing time.
